Home >>
Products >> Silicone Turbo Charger Hoses/Marine Hoses
Silicone Turbo Charger Hoses/Marine Hoses
Turbocharger hoses are used in
Automobiles to withstand exhaust gases, corrosive oils & elevalated
temperatures under the hood. The construction of a turbocharger hoses
is determined depending upon the service conditions of the hose.
Materials
Turbocharger hoses are made from Silicone rubber & if there are
highly corrosive oils, coolants or vapors in contact, an inner lining of
0.5mm thickness of Fluorosilicone rubber is recommended.
Reinforcement
The reinforcing fabric is usually polyester. However if the temperature &
pressure requirement is high, aramid fabrics such as NOMEX®
or KEVLAR® are used.
Design
1) Straight or Shaped hoses with smooth outer surface.
2) Convoluted / Corrugated in shape. The number of convolutes depend on the
length of the hose. Stainless steel rings are fitted in the grooves on the
outer surface to give the hose additional pressure resistance.
Marine Hoses
Materials
Marine hoses are made from Silicone rubber and reinforced with Woven
Polyster. Woven meta-aramid is used in some cases where continous working
temperatures are above 200 deg. C.
All our hoses are certified by an external laboratory, and meet all
requirements of SAE J2006-R3.
Application
Marine Wet Exhaust Systems, Marine cooling to motor, and Hot water transfer
from motor to exhaust.
Sizes Available
Sizes are available in straight, single hump and double hump designs, from
1 inch bore to 16 inch bore